Re: [Hamlib-developer] rigctl send_cmd

[Bill S. <g4...@cl...>]

On 07/02/2018 00:01, Jere Sandidge wrote:
> Bill,
> See below:
>
> rigctl -m 135 -r /dev/tty.SLAB_USBtoUART -s 9600 -t\; w FA -vvvvv
> rigctl, Hamlib 3.0.1
> Report bugs to <ham...@li... 
> <mailto:ham...@li...>>
>
> rig:rig_init called
> yaesu: initrigs3_yaesu called
> rig_register (121)
> rig_register (127)
> rig_register (110)
> rig_register (105)
> rig_register (106)
> rig_register (107)
> rig_register (109)
> rig_register (120)
> rig_register (101)
> rig_register (122)
> rig_register (123)
> rig_register (111)
> rig_register (115)
> rig_register (113)
> rig_register (114)
> rig_register (128)
> rig_register (131)
> rig_register (116)
> rig_register (103)
> rig_register (124)
> rig_register (104)
> rig_register (125)
> rig_register (129)
> rig_register (132)
> rig_register (130)
> rig_register (117)
> rig_register (119)
> rig_register (118)
> rig_register (126)
> rig_register (133)
> rig_register (134)
> rig_register (135)
> ft991_init called, version 0.22.4
> newcat_init called
> rig:rig_open called
> newcat_open called
> newcat_open: write_delay = 0 msec
> newcat_open: post_write_delay = 50 msec
> newcat_set_trn called
> newcat_valid_command called
> newcat_valid_command AI
> cmd_str = AI0;
> cmd_str = AI0;
> write_block(): TX 4 bytes
> 0000    41 49 30 3b   AI0;
> cmd_str = ID;
> write_block(): TX 3 bytes
> 0000    49 44 3b                                            ID;
> read_string(): RX 7 characters
> 0000    49 44 30 36 37 30 3b   ID0670;
> newcat_set_cmd: read count = 7, ret_data = ID0670;
> newcat_get_vfo called
> newcat_valid_command called
> newcat_valid_command VS
> newcat_valid_command: 'FT-991' command 'VS' not supported
> Opened rig model 135, 'FT-991'
> Backend version: 0.22.4, Status: Beta
> write_block(): TX 0 bytes
> read_string(): Timed out 2.1470 seconds after 0 chars
> rig:rig_close called
> newcat_close called
> rig:rig_cleanup called
> newcat_cleanup called
>
> Jere

Hi Jere,

I believe commands have to be after all command line options, try this:

rigctl -m 135 -r /dev/tty.SLAB_USBtoUART -s 9600 -t\; -vvvvv w FA

BTW the VS command not supported message is bogus and can be ignored, 
the latest master branch code does not try and invoke a VS; command on 
the FT-991(A).

73
Bill
G4WJS.