Hello Stephane,
Stephane Fillod wrote:
>
> On Thu, Feb 28, 2002, ham...@li... wrote:
> >
> > 1. CVS: hamlib/include/hamlib rig.h,1.60,1.61 (Francois Retief)
>
> [...]
>
> > ***************
> > *** 360,363 ****
> > --- 360,365 ----
> > #define RIG_SCAN_PROG (1L<<3) /* Programmed(edge) scan */
> > #define RIG_SCAN_DELTA (1L<<4) /* delta-f scan */
> > + #define RIG_SCAN_RESUME_ON (1L<<5) /* Scan resume ON (IC-910H) */
> > + #define RIG_SCAN_RESUME_OFF (1L<<6) /* Scan resume OFF (IC-910H) */
> >
>
> Francois, don't you think it should be RIG_FUNC_RESUME instead ?
>
I am not sure. The routine that uses this constant is rig_scan(..)
But this routine has no extra variable to switch on/off the resume
function. That is why I added the constants as it is above.
Maybe we should change it to a function, ie. RIG_FUNC_SCAN_RESUME.
Then we can use rig_set_func(..) to enable/disable the scan resume
function.
Quote from the manual:
"Scan resume ON/OFF
You can select the scan to resume or cancel when re-
ceiving a signal, in the scan set mode. Scan resume
ON/OFF must be set before operating a scan."
What do you think?
Cheers
Francois Retief
--
---------------------------------------------------------------------
Electronic Systems Laboratory (ESL)
University of Stellenbosch
South Africa
Tel. +27-21-808-4472
** Developers of the SUNSAT micro-satellite **
http://sunsat.ee.sun.ac.za
|
