I installed GMFSK 0.6 with Hamlib 1.2.3
Everything works fine, the CAT sign is flashing and GMFSK is reading out frequencies etc.
But....I cannot get the PTT via CAT to work...Any ideas?
73, Uwe
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
No idea either.
We do need input, like full protocol traces from the "rigctl -vvvvvv" program, and executing the set_ptt command.
It's worth checking also your Yeasu user manual to see if the PTT command sent is right (from traces above).
73, Stphane
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello all,
I installed GMFSK 0.6 with Hamlib 1.2.3
Everything works fine, the CAT sign is flashing and GMFSK is reading out frequencies etc.
But....I cannot get the PTT via CAT to work...Any ideas?
73, Uwe
No idea either.
We do need input, like full protocol traces from the "rigctl -vvvvvv" program, and executing the set_ptt command.
It's worth checking also your Yeasu user manual to see if the PTT command sent is right (from traces above).
73, Stphane
I will try to get some results, but I am sorry, I am not an expert.
Anyway, will let you know.
Bonne chance
Uwe / DF3HS