Help: using SR-SP2 with GXSM on Ventiotec's Ubuntu 12.04

Help
2014-02-17
2014-02-18
  • Cassiano Rabelo

    Cassiano Rabelo - 2014-02-17

    Hello.

    At our lab we are trying to setup a new STM system using GXSM and a Signal Ranger SR-SP2 board.

    I have downloaded and installed the very handy linux-distribution by the folks at Ventiotec.de (Ubuntu 12.0.4 LTS).
    If I plug my Signal Ranger SR-SP2 to the USB port, I see it being added to the /dev/ folder (/dev/sranger0). I'm also able to send instructions to it using the "loadusb -m" command. But if I open GXSM and choose "SRANGER:SPM" as the "Hardware/Card" (this is what I should do, right?) and restart GXSM, it no longer launches. I only get the following in my terminal session and then I'm back into the command prompt:

    GXSM-DebugLevel/PI-DebugLevel/ForceGDefaults: 0/0/0
    DSPDev :/dev/sranger0
    DSPType:SRanger:SPM

    I'm wondering if this has anything to do with the firmware update file that is placed in the desktop by the linux installer (firmware for STD_SP2 version 1058.out). How do we use/apply this firmware update?

    Any help will be greatly appreciated.

    Best regards,
    Cassiano Rabelo

     
  • Percy Zahl

    Percy Zahl - 2014-02-18

    see response in install knowledge board

     

Log in to post a comment.

Get latest updates about Open Source Projects, Conferences and News.

Sign up for the SourceForge newsletter:





No, thanks