Cassiano Rabelo - 2014-02-17

Hello.

At our lab we are trying to setup a new STM system using GXSM and a Signal Ranger SR-SP2 board.

I have downloaded and installed the very handy linux-distribution by the folks at Ventiotec.de (Ubuntu 12.0.4 LTS).
If I plug my Signal Ranger SR-SP2 to the USB port, I see it being added to the /dev/ folder (/dev/sranger0). I'm also able to send instructions to it using the "loadusb -m" command. But if I open GXSM and choose "SRANGER:SPM" as the "Hardware/Card" (this is what I should do, right?) and restart GXSM, it no longer launches. I only get the following in my terminal session and then I'm back into the command prompt:

GXSM-DebugLevel/PI-DebugLevel/ForceGDefaults: 0/0/0
DSPDev :/dev/sranger0
DSPType:SRanger:SPM

I'm wondering if this has anything to do with the firmware update file that is placed in the desktop by the linux installer (firmware for STD_SP2 version 1058.out). How do we use/apply this firmware update?

Any help will be greatly appreciated.

Best regards,
Cassiano Rabelo