From: smerry <seb...@gm...> - 2008-04-21 05:06:16
|
Hi all, Does anyone have exact instructions for setting up the Robostix with the i2c-io program with a gumstix (verdex) that has the OE version? I used the buildroot and had it working before, but then I decided to upgrade to the OE and have been lost. I have the i2c-Boot-m128-16MHz.hex file on the gumstix and I am trying to upload that to the Robostix. I setup the jumpers on the Robostix, but I cannot seem to use uisp: "root@gumstix-custom-verdex:~$ uisp Probably the AVR MCU is not in the RESET state. Check it out and run me again." I have a feeling it has to do with the fact that I have not installed the robostix_drv.ko. But I have no idea where that is in OE. I even tried using an old robostix_drv.ko (from when I used buildroot) but it told me there was an error inserting the 'robostix_drv.ko' due to an invalid module format (which I half expected, but decided to try anyway). Basically I would love to know where all the files I need are (or what I need to do to get them) and in what order to set them up. There seem to be so many articles all over the place, but some don't work for OE. Thanks in advance! -Sebastian -- View this message in context: http://www.nabble.com/Gumstix--w-OE-and-Robostix---How-do-I-get-them-to-work--tp16802798p16802798.html Sent from the Gumstix mailing list archive at Nabble.com. |