[Gumstix-users] Segmentation fault with uisp

[Thierry G. <thi...@re...>]

Hi,

I have a Gumstix Connex 400-bt with release 549 on it. I just  
purchased a Robostix and I spent some time today going through the  
steps necessary to activate i2c communication between the Gumstix and  
the Robostix.

So, I followed http://docwiki.gumstix.org/Robostix_gumstix_ISP,  
choosing the precompiled files. When I executed uisp --erase --upload  
if=Flash-LED.hex I ran into a Segmentation fault. I ignored it, and  
uploaded Simple-Flasher.hex instead. It worked and the LEDs flashed as  
required.

I proceeded to the installation of i2c on the Gumstix (http://docwiki.gumstix.org/I2C_on_the_Gumstix 
). It worked, except that I did not see any output from modprobe i2c- 
dev and modprobe i2c-pxa. Once again, I went with the precompiled files.

Then, I tried to install i2c-BootLoader and when I execute uisp -- 
erase --upload if=i2c-Boot-m128-16MHz.hex, I get a Segmentation fault.  
I tried with the precompiled i2c-Boot-m128-16MHz.hex, and with one I  
compiled myself (Ubuntu with avr-gcc 4.2.1).

Do you know where this problem could come from ?

Thanks.
--
Thierry Genovese

PS : Sorry for my english, I'm French.