What I need to do (on a verdex) is tap into quite a few pins on both the 60
and 120 pin connectors (the keyboard controller lines, to be exact). The
problem is, I need to able to use an Audiostix2, and a netCF-120 (when
released), which rules out simply getting a connector and soldering to it.
So far, the only solution for such a problem I've came up with is a
Tweener-like breakout board. All it would do would allow access to all the
pins of the connector (60,92,120 whatever type it is), with a pass through
like the tweener allowing the use of another expansion board. Is there any
plans for such a board in the future (If not; does anyone have a good place
on the Internet where I could get such a PCB made?)
Unrelated note, looks like the JTAG board for the verdex was
From: Dave Hylands <dhylands@gm...> - 2007-05-02 21:58:42
On 5/2/07, Ian Smith <itsmith@...> wrote:
> how much current i safely draw off the vcc lines on the breakout-gs?
I think that the voltage regulator is rated at 150 mA and nothing on
the board actually uses it (except maybe a pullup for FF_RxD).
Vancouver, BC, Canada
Get latest updates about Open Source Projects, Conferences and News.