I recently received my connex 200 gumstix board and was trying to get it to
work with a waysmall stuart board. I set up everything on the computer and
seemed to work smoothly, except it was stuck in a reboot cycle. I
re-flashed my buildroot with one I built myself, and everything still works
except for the the reboot thing. Here is a copy of the terminal output:
U-Boot 1.1.2 (Feb 1 2006 - 16:55:50)
*** Welcome to Gumstix ***
U-Boot code: A3F00000 -> A3F239D4 BSS: -> A3F58A80
Bank #0: a0000000 64 MB
Flash: 16 MB
Using default environment
Hit any key to stop autoboot: 0
### JFFS2 loading 'boot/uImage' to 0xa2000000
Scanning JFFS2 FS: . Unknown node type: 2006 len 7040 offset 0x1e480
Unknown node type: 2006 len 3416 offset 0x3f2a8
... ( lots of these - normal according to the tutorial on re-flashing?)
\ Unknown node type: 2006 len 2136 offset 0xb1f7a8
### JFFS2 load complete: 744832 bytes loaded to 0xa2000000
## Booting image at a2000000 ...
Image Name: uImage
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 744768 Bytes = 727.3 kB
Load Address: a0008000
Entry Point: a0008000
Verifying Checksum ... OK
Starting kernel ...
pc : [<a0e8555c>] lr : [<a0008854>]
sp : a00c7110 ip : a00c6b78 fp : a00c7138
r10: a00bdcd4 r9 : a0000000 r8 : a0000100
r7 : 00000020 r6 : 00000004 r5 : a00c7114 r4 : a0408000
r3 : a00c5d50 r2 : a00c5d6c r1 : a00c8b68 r0 : 00000000
Flags: nZCv IRQs off FIQs off Mode SVC_32
Resetting CPU ...
Was this thing broken when I arrived, or is there some fix? Any help would
be appreciated. Thanks. -brad
On 8/21/06, Jesse Welling <jesse.welling@...> wrote:
> This could be the issue of U-boot boot args not being set up correctly
> Check out this page http://docwiki.gumstix.org/U-Boot.
> I would check your boot arg in U-boot with 'printenv'
> -Jesse W.
Wait I missread the error....but it doesn't hurt to check the boot arg to
make sure they arn't the problem (^^;)
Get latest updates about Open Source Projects, Conferences and News.