From: Colin Sauze <cjs06@ab...> - 2007-06-13 16:58:40
Can anyone tell me which UART on the breakout-gs is which? On my
breakout-gs its not obvious, I have a set of 4 holes labelled
gnd,txd,vcc and rxd near the power connector but on the other side of
Then I have holes labelled bt_uart at the top of the board (the top when
holding it so the power/usb are at the bottom). These are labelled
Then on the other side (same side as the power and usb connectors) I
have two sets just labelled RXD,VCC,TXD and GND.
Can anyone tell me which is which? Are all four uarts exposed? According
to the wiki the breakout-gs only has 3 uarts? Are there still 3 usable
uarts when a cfstix is in use?
PhD Student, Intelligent Robotics Group
Department of Computer Science
University of Wales, Aberystwyth
SY23 3DB, United Kingdom