For designing SDIO interface with Connex400, i was going through eagle
Schematic of netMMC. there i found conflict in pull-up resistor connections
for SD signals.
1.on page *1*/5, *GPIO56_SD_RW* and *GPIO50_SD_IRQ* are connected to
*51k*pull-up resistor bank.
2.on page *3*/5 , *GPIO56_SD_RW* and *GPIO50_SD_IRQ* are connected to
*100k*pull-up resistor bank.
3.signals *GPIO51_SD_CD* and *GPIO54_SD_WP *are *not* connected to any
pull-up resistor bank.
Pls let me know if there is some mistake or my misinterpretation.