I needed to use the NSSP/SPI on the gumstix and used the sample code, straight off the wiki. I first checked out the buildroot for our connex gumstix and compiled the code. I probed the NSSP lines with a scope and everything worked fine while running the sample code. I then went on to separate the NSSP code into a separate module so that I can use it for my application. It compiled without errors, but while executing I get a BUS ERROR. After looking at a couple of diffs, I still could'nt find any code mismatches so I went back to the sample code on the wiki. Copy, paste, compile... and now I get the same BUS ERROR on the code that previously worked. Same thing happens on a different connex. I then decided to move over to our verdex, but I can't seem to checkout ANY buildroot now without a password (svn co -r1559 http://svn.gumstix.com/gumstix-buildroot/trunk gumstix-buildroot) ?
Did try the following (and different revisions):
svn co --username gumstix --password gumstix -r1559 http://svn.gumstix.com/gumstix-buildroot/trunk buildroot1559
svn: PROPFIND request failed on '/gumstix-buildroot/trunk'
svn: PROPFIND of '/gumstix-buildroot/trunk': 500 Internal Server Error (http://svn.gumstix.com)
Any suggestions will be appreciated!
This message is subject to the CSIR's copyright terms and conditions, e-mail legal notice, and implemented Open Document Format (ODF) standard.
The full disclaimer details can be found at http://www.csir.co.za/disclaimer.html.
This message has been scanned for viruses and dangerous content by MailScanner,
and is believed to be clean. MailScanner thanks Transtec Computers for their support.