I just bricked a rev 0.9 gumstix; It's too expensive (both on money and
time terms) for me to return it to recording on gumstix, besides I have
an electronic lab at work, so I was wondering if someone has
schematics/board layouts so that the guys at work could build a board
for me to connect the gumstix throught the testing points. I have a
wiggler clones around.
I was also wondering if I can power the gumstix normally (i.e. through
the 60 pin connector), and have a common ground with the wiggler?
Otherwise would I have to power the gumstix via test points? Is there a
test point to use the regulator on-board, so that I can feed unregulated
I'm a software man so my electronics is primitive at best.