I'am developing an extension board for a Verdex XL6P. This board will be
connected using the 60-pin connector.
I need to have an USB host on that board (using an USB A connector). After
reading the documentation and the different schematics available on internet
I still have a few questions I can't answer :
1) If I'm using the USB port 2 as host through the 60-pin connector, how can
I access USB enable and USB PWR ? There is no direct connection to those PXA
pins? Can I just leave them unconnected and not signal over-current to the
2) If I don't want to use the otg mode (not available on A connector), can I
just leave it unconnected ?
3) Do I need to use a transceiver to convert D-/D+ signal form the iMx
(3.3V?) to 5V output on the connector?
Thank you in advance for your help
View this message in context: http://www.nabble.com/USB-on-Verdex-XL6P-tp21029549p21029549.html
Sent from the Gumstix mailing list archive at Nabble.com.