I have a small question to ask about the touchscreen connection.
I have seen the adtasheet of the touchscreen and the pinouts are as =
now if i connect these pins to Audiostix accordingly then TSLIB doesn't =
but if i connect them like so:
then TSLIB responds and gives out readings from ts_print of coordinates =
X(from 1-500),Y(from 1-500),but Z always remains the same no matter =
where i press the screen.
Is this due to TSLIB configuration that this order of pins works? or =
does it have to do with something else?
I've managed to get the Touchscreen wired up to Audistix with some =
Variable resistors crossing some pins to get the Z value moving (which =
was static if i would just plug the touchscreen pins to the board).
The values of Z now go from 100 to 800 but still TSLIB doesn;t get that =
as a Press when i startup ts_calibrate should the value go to 1000 to =
get the ts_calibrate working?
the X and Y values go from 150 to 800 also.
If anyone managed to wire the touchscreen correctly could he please help =
me out here?
Has anyone connected and operated successfully a touchscreen with =
I am trying to connect the touchscreen that is on the=20
Panasonic EDMGRB8KJF LCD
but i can't seem to be able to make it work properly by just connecting =
the 4 pins to the UCB1400 pins, i think that there is some kind of =
cercuitry that must be done to the pins before i connect it to gumstix. =
Or maybie anyone has used any touchscreen controller from Earth LCD with =
Please help me out here.