I am adding a third Ethernet controller to the EM Bus on my Gumstix Overo
Fire... Basically, I'm making a base board which is like a Tobi Duo, but
with 3 Ethernet ports (let's not call it a Tobi Tri for copyright reasons ;)
I'm going to use the EM bus (16 data, 10 address lines)
I'm going to use EM Bus Chip Select 4 pin
I'm going to use one of the available GPIO pins as an interrupt
Q1) I don't think I need to connect anything else to the Gumstix, do I?
Q2) I have to configure the pins I use for the CS and INT in the boot
source, but do I have to do anything else to tell the OS that there's a
third device? I.e. will it probe the bus automatically?
Q3) Is there any restriction on which GPIO pin I use for the third
Ethernet's Interrupt? (As long as it's not in use for anything else)
Thanks very much,
Get latest updates about Open Source Projects, Conferences and News.