Mkae sure you disable the touchscreen driver in the kernel config.

Philip


How can i fix the issue if i want the touchscreen enable ?

regards,

 
>
> I setted the interface in overo-board.c as:
>
>          {
>                  .modalias = "*spidev*",
>                  .bus_num = 1,
>                  .chip_select = 0,
>                  .max_speed_hz = 500000
>                  .mode = SPI_MODE_1,
>          },
>
> but when booting the system, the kernel hangs:
>
> -----
> NAND read: device 0 offset 0x280000, size 0x400000
>   4194304 bytes read: OK
> ## Booting kernel from Legacy Image at 82000000 ...
>     Image Name:   Angstrom/2.6.33/overo
>     Image Type:   ARM Linux Kernel Image (uncompressed)
>     Data Size:    3161148 Bytes =  3 MB
>     Load Address: 80008000
>     Entry Point:  80008000
>     Verifying Checksum ... OK
>     Loading Kernel Image ... OK
> OK
>
> Starting kernel ...
>
> Uncompressing Linux... done, booting the kernel.
> -----
>
> The build system is a fresh one using Linux Kernel 2.6.33
> (linux-omap3-2.6.33), my goal is to have the spidev entry in the devices
> list as /dev/spidev1.0. I tried this solution in a previous Gumstix system
> with kernel 2.6.32 but now is not longer working in 2.6.33, any help is
> appreciated,
>
> best regards,
>
>
>
>
> ------------------------------------------------------------------------------
>
>
>
> _______________________________________________
> gumstix-users mailing list
> gumstix-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/gumstix-users

------------------------------------------------------------------------------
_______________________________________________
gumstix-users mailing list
gumstix-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/gumstix-users






--
Eduardo Silva
http://edsiper.linuxchile.cl
http://www.monkey-project.com