If anyone is curious, turns out the SPI1 clock was shorted to ground through the level shifter U?8 (pins 47 and 48 where shorted) beyond that, most of the PCB looked a bit burned (discolored solder mask). Just a friendly note to anyone with a similar experience, may really be a HW issue. After reflowing U?8 with a hot air pencil, and cleaning up the short, the touch screen came to life!

Now onto SW design challenges and other fun tasks.

-Alex 

On Tue, Dec 15, 2009 at 9:01 PM, Alex Stewart <kingsquirrel@gmail.com> wrote:
I've probed all the relevant SPI signals found on the 40 pin header with an oscilloscope. They all look fine except SPI1_CLK never toggles. Is there some way to confirm the gpio mux settings are correct? This is using a stock flash image booting from NAND (the one the board shipped with) Also its an overo-water.
-Alex

On Tue, Dec 15, 2009 at 6:15 PM, Alex Stewart <kingsquirrel@gmail.com> wrote:
Hi list,
Just connected up the 4.3" lcd, and set the uboot display to lcd43. System boots fine and the lcd comes to life however the touchscreen does not. Kernel log is reporting:
"ads7846 spi1.0: touchscreen, irq 274
ads7846 spi1.0: no device detected, test read result was 0x00000000" 

Is there anything special that needs to be done in u-boot or the system to enable the gpio to get the touch screen to work? or is setting the display variable in uboot to lcd43 all that is needed?

Im new to this system and I'm trying to figure out if Im doing something wrong in SW, or if my new board is simply bad.

Thanks!
-Alex