Hi Dave,

Excuse my ignorance but I have no experience of programming fuses. How would I go about this?

Thanks,

Lee

On 25/03/2008, Dave Hylands <dhylands@gmail.com> wrote:
Hi Lee,


> I have recently bought a Robostix R1131, having already used a R790, and am
> having trouble getting it to work in standalone mode. I've made the pull up
> resistor modification as described on the Robostix Wiki but it still won't
> work. I can program the board OK and it verifies, but doesn't actually run.


To the best of my knowledge, there aren't any modifications required
in order to get the robostix to run in standalone mode. By standalone,
I mean with no gumstix plugged in.

You need to program the fuses properly. From the factory, the
ATMega128 is only running at 1 MHz and its in ATMega103 compatability
mode.

--
Dave Hylands
Vancouver, BC, Canada
http://www.DaveHylands.com/

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
gumstix-users mailing list
gumstix-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/gumstix-users