This isn't from experience, but I would try JTAG: use the debugger to stop the processor, load a copy of u-boot into memory at the correct address (0x5C000000 from my file) and then tell it to execute there.  If you're lucky, u-boot will fire right up and then you can use it to reflash the board.


On Nov 20, 2007 12:40 PM, Anthony DiRenzo <> wrote:
I have a Verdex XL6P which I have been experimenting with via reflashing, erasing, etc and have accidently rendered the device useless.
Is there a way I can reflash this device myself without sending it back to the factory?
Where can I find the procedures for doing that if its possible?

Never miss a thing. Make Yahoo your homepage.

This email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
gumstix-users mailing list