I've designed a small interface board so that I can connect a USB webcam to the Verdex XL6P through the 24-pin (HFK124CT-ND) connector. By searching through old posts, I found *this* and based on Matt Krugmans post, which directed me *here*, I've designed the following board:

http://folk.ntnu.no/josteija/webshare/GumstixUSBHost_schematic_rev1.png
http://folk.ntnu.no/josteija/webshare/GumstixUSBHost_board_rev1.png

Essentially, all I want to use it for is the USB and IC capabilities, but i added pinouts for all other pins as well - just in case.

I thought I'd ask you guys if you see any obvious errors I've made (or if you have any other comments) before I produce the board?

Regards
Jostein Austvik Jacobsen