From what I recall you have to go through aptina’s website to get the datasheet. They normally take a few days to okay you to download a datasheet.

 

 

 

 

From: RayS [mailto:rays@blue-cove.com]
Sent: Tuesday, August 04, 2009 8:48 AM
To: gumstix-users@lists.sourceforge.net
Subject: Re: [Gumstix-users] Looking for a camera sensor capable of 30 fps to connect to a Gumstix Overo Water

 

The MT9N001 appears to be a camera (?) do you have a link to the chip datasheet?
In any case I'm most interested in the driver/software side and actually getting the data in via J5. I am interested in the pipeline, but a smaller chip with larger pixels.
I can also often get chips via the instrument company I consult for - I have some top-end 100+MHz 16bit ADCs for instance, usually used for O-scopes. If someone would like some trades that would be good too.

Thank you,
Ray

At 08:27 AM 8/4/2009 -0700, charkear wrote:


I have a camera board that I made for the J5 connector on the gumstix.  It
uses a 9MP micron sensor MT9N001I12STC.  The board is really simple.  Has
three voltage regulators some caps and resistors and the micron sensor.  It
is 1.1" x 1.1" and uses an M12X.5 lens threaded mount.  I have not had the
time to write a driver for it in linux.  There are several drivers for
similar sensors available to modify. 

If anyone is interested email me.  Getting a hold of the micron sensors is
not easy.  I got lucky with an Arrow Electronics representative willing to
sell me 5. 

Charles Kearney