I have a ncurses interface that runs on a Verdex equipped robot.  It is a diagnostic program that is run from the command line.
Everything works fine over ssh (bluetooth or 802.11) but the interface breaks as soon as it starts when I run it over serial.

I am using wermit on Mac OS X 10.4 for serial communication
The gumstix is a Verdex XL6P with a wifistix attached

Since the code runs fine over ssh I am assuming it is an issue with wermit or ncurses, just wanted to see if anyone had some insight.


Brett Hemes
UMN Center for Distributed Robotics