Is your pre-compiled image exactly the same as 1533 or do you have some mods/patches on top of it?
----- Original Message ----
From: Dave Hylands <firstname.lastname@example.org>
To: General mailing list for gumstix users. <email@example.com>
Sent: Tuesday, November 20, 2007 10:00:50 AM
Subject: Re: [Gumstix-users] Bluetooth, 802.11, and Etherner Not Working Out of Box
> Just received my Gumstix today and I think there may be something
> the board(s). I have a Verdex Mainboard with Bluetooth, a
> tweener, and a console VX. The Bluetooth does not appear to work. The
> doesn't appear to work, and wired ethernet doesn't appear to work.
> what I'm seeing in the bootlog -
> U-Boot 1.2.0 (May 16 2007 - 11:17:32) - PXA270@400 MHz - 1407
> Any ideas? Do I have one or more defective boards? Based on what I've
> would expect the kernel to detect Bluetooth, 802.11, and ethernet but
> doesn't appear to be happening.
The gumstix are being shipped with an image for the netCF board. You
can either grab the latest buildroot, or try a precompiled image I put
together over here::
You'll want the rootfs and uImage files. You'll probably want to
update u-boot as well, if you want to use the microSD card from within
u-boot. Use the u-boot-911x.bin file.
To reflash u-boot, you need to drop into the u-boot GUM> prompt by
pressing a key on the serial console during the 3 second countdown
that happens at boot time. I normally use the serial console and
Y-Modem file transfer:
crc32 a2000000 $filesize
Verify that crc32 matches crc32 of source u-boot. For the one
mentioned above, the correct CRC is
0x869cea29. if the crc doesn't
match, don't proceed.
protect off 1:0-1
cp.b a2000000 0 $filesize
crc32 0 $filesize
the erase instruction above erases the flash, so if anything happens
(like you lose power) between then and the successful completion of
the cp.b command then your gumstix is bricked.
If the second crc fails, then you'll need to redo things. It's very
important not to poweroff or otherwise reset the processor between the
erase command and a successful crc32 command. You can always
redownload, and reerase.
Once u-boot has been upgraded successfully, then you can do a
and it will reset the processor and run the new u-boot. You should see
the revsion number updated. I normally prefer to use the microSD card
to transfer rootfs and uImage since they're so large.
This page has some more information:
Vancouver, BC, Canadahttp://www.DaveHylands.com/
email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
gumstix-users mailing firstname.lastname@example.org://lists.sourceforge.net/lists/listinfo/gumstix-users