Hello, thanks for the prompt reply.

I see the two pads, and I've used a tester to check the continuity between these and the three solder points on the power jack.

...  It's working now.  Must have been my bad soldering...  Thanks again.

BTW, what does the J in J_GND mean?

On Tue, Apr 8, 2008 at 5:01 PM, Dave Hylands <dhylands@gmail.com> wrote:
Hi Albert,

On Tue, Apr 8, 2008 at 10:57 AM, Albert Ng <twinwing@gmail.com> wrote:
> Hi all, just a quick question regarding the Breakout GS.
>
> I'm using the Breakout for a little project and already have 12V power
> supply, so I thought I'd use a DC-DC converter and get the necesary 5V from
> there.
>
> Looking through the schematics for the Breakout GS, I've come across
> http://pubs.gumstix.org/boards/BREAKOUT/GS/PCB00011-R901/B00011.JACK.png
> that seems to indicate that V_BATT would be where I should connect one of
> the terminals of the power supply.

If you have Rev 901, then there is a 2 pad connector across the board
from the power jack. This two pad connector has V_BATT and GND on it.
That would be the logical place to connect up the power and ground.

--
Dave Hylands
Vancouver, BC, Canada
http://www.DaveHylands.com/

-------------------------------------------------------------------------
This SF.net email is sponsored by the 2008 JavaOne(SM) Conference
Register now and save $200. Hurry, offer ends at 11:59 p.m.,
Monday, April 7! Use priority code J8TLD2.
http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone
_______________________________________________
gumstix-users mailing list
gumstix-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/gumstix-users