In my build (1431) I was able to get SSP support by modifying arch/arm/mach-pxa/Kconfig (in the Linux kernel source directory), then rebuilding the kernel. Towards the top of the file, I have:



        bool "Gumstix Platform"

        depends on ARCH_PXA

        select PXA_SSP


I did this about 6 months ago and can’t recall if there was anything else I needed to do, but I think this is it.


Hope that helps…




From: [] On Behalf Of Lee Carraher
Sent: Thursday, December 27, 2007 7:57 PM
Subject: [Gumstix-users] Enabling SSP in the kernel


I am trying to enable the nssp/ssp port available on the console-lcd breakout board in order to interface with the knockoff Nokia 6100 LCD screen.
following the instruction on this wiki page
I am unable to find the gumstix configuration in Kconfig. The wiki has a note to add the new location however it hasn't been added.
Does anyone know where it is. Or have any instructions for communicating with the screen for the current buildroot? Any advice or help is appreciated.


NOTE: The information in this message is intended for the personal and confidential use of the designated recipient(s) named above. To the extent the recipient(s) is/are bound by a non-disclosure agreement, or other agreement that contains an obligation of confidentiality, with AuthenTec, then this message and/or any attachments shall be considered confidential information and subject to the confidentiality terms of that agreement.  If the reader of this message is not the intended recipient named above, you are notified that you have received this document in error, and any review, dissemination, distribution or copying of this message is strictly prohibited. If you have received this document in error, please delete the original message and notify the sender immediately.


Thank you.


AuthenTec, Inc.