On 8/12/2010 7:14 AM, Ken Ho wrote:



We try to setup an ip address inside the gumstick module.

It seems doesn’t work on either dynamic or static ip setting.


It work on an loop back setting ,however.


Please advice.



You might be having a similar problem to what we had due to the way our network is setup.

You have either set or uncommented the line ?

auto eth0
iface eth0 inet dhcp

then run
ifdown eth0
ifup eth0

If still no ip address

then run
dhclient eth0 


UTS CRICOS Provider Code: 00099F
DISCLAIMER: This email message and any accompanying attachments may contain confidential information. If you are not the intended recipient, do not read, use, disseminate, distribute or copy this message or attachments. If you have received this message in error, please notify the sender immediately and delete this message. Any views expressed in this message are those of the individual sender, except where the sender expressly, and with authority, states them to be the views the University of Technology, Sydney. Before opening any attachments, please check them for viruses and defects.