On 20/04/2010 3:12 AM, jac02000 wrote:
I take it the HDMI can plug directly into the monitor?

I have a Overo hooked into the Tobi board.

The monitor currently states no signal.

Is there anything I need to activate to get the monitor going?


  

Are you using the factory image ?
Or running from a later one on a micro sd card ?

Try running a more recent image from the micro sd card

one of these ones (desktop image)
http://www.sakoman.com/feeds/omap3/glibc/images/overo/

Probably better to not use the very latest ones as they are still a bit unstable

instructions for using them are at
www.gumstix.net/Setup-and-Programming/view/Overo-Setup-and-Programming/Downloading-pre-built-images/111.html


Or you could build an image using the online angstrom image builder
www.angstrom-distribution.org/narcissus/

Alex


UTS CRICOS Provider Code: 00099F
DISCLAIMER: This email message and any accompanying attachments may contain confidential information. If you are not the intended recipient, do not read, use, disseminate, distribute or copy this message or attachments. If you have received this message in error, please notify the sender immediately and delete this message. Any views expressed in this message are those of the individual sender, except where the sender expressly, and with authority, states them to be the views the University of Technology, Sydney. Before opening any attachments, please check them for viruses and defects.