Hi all.

Right off the bat  I popped the ribbon cable 'lock' lever off of the
connector on my Caspa.

So I got the stereoscope lined up, got the lever in my hot little
tweasers, and tried to put the hinge pins back into the connector
on the Caspa board.

Utter failure: I snapped off the pin on the lever that is supposed to
be captured by the connector.

I'm ready now for the 'big guns' and am ready to try and connect the
ribbon cable permanently. I was thinking super glue; hot glue; epoxy;
kaplan tape.... etc.

Is there any mechanical thing I can do to help ensure that the ribbon
cable will make good contact with the plastic recepticle _without_
having the locking lever available?

Any suggestions for adhesives?

Tks all!