Yes, you can.
If by loop-split, you mean the gSculpt bandsaw tool, you want the n-bandsaw tool. It places any number of equally spaced splits you want.
There are similar versions of cut (n-cut), split (n-split), and connect (n-connect).
Regards
Geoffrey French
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
Is it possible to snap to the midpoints of edges? Or is there any way to make a loop-split down the middle of an edge?
Hi,
Yes, you can.
If by loop-split, you mean the gSculpt bandsaw tool, you want the n-bandsaw tool. It places any number of equally spaced splits you want.
There are similar versions of cut (n-cut), split (n-split), and connect (n-connect).
Regards
Geoffrey French
Great! Thanks for the tip :)