Migrate from GitHub to SourceForge with this tool. Check out all of SourceForge's recent improvements.
Close

ytics overlap in 3d splot

Help
2013-09-11
2013-09-11
  • sree badugula

    sree badugula - 2013-09-11

    Hi,

    I have two doubts

    1. I am using splot for 3d graphs.
      But y axis tics are overlapped.

    x and z axis tics are fine..

    how to overcome this y axis tics overlap

    1. what is the differences between grid and dgrid3d in gnupot

    Thanks

     
    Last edit: sree badugula 2013-09-11
  • Christoph Bersch

    1. You can use set tics front to move the tics to the front. But that also puts the grid (if you have one) to the front.

    2. See help grid and help dgrid3d! set grid draws a grid, set dgrid3d is for mapping scattered data to a regular grid.

     
  • sree badugula

    sree badugula - 2013-09-11

    Thanks for reply,

    1. i have already used the set tics front in my script file but no use..

    its not working . only y axis tics values are overlaaping

     
  • Christoph Bersch

    Well, in that case you should provide some information about your plot. Please provide a minimal example script which shows the problem, and, ideally also an image. Its quite hard to guess your settings...

     
  • sree badugula

    sree badugula - 2013-09-11

    Please find the attachment for script file and output file

     
  • sree badugula

    sree badugula - 2013-09-11

    Output file..
    Please observe Y-axis values are overlapped

     
  • Christoph Bersch

    Your separation between tics on the y-axis differs by 5(!) orders of magnitude. Either the fine subdivisions below 86400 are not important, or you should consider using a logscale for the y-axis (set logscale y).

     

Log in to post a comment.