[Gimp-print-devel] Random Success...

[Karl H. K. <kh...@kh...>]

I think I said this before: I don't understand the weird interactions
between the moon phase, the outside temperature, the image contents
and my successrate when printing images via the plugin:

I just tried to run a test using all print modes on my stc740. The
first image I tried caused the "blank page" problem even though I=20
knew that the printer was doing fine yesterday. So I assumed that
it must have been the small changes Robert checked in since then.
Therefore I'm going back to the version I had yesterday and tried
it again withe same result. It did not work with the test image
that I'm always using. So I loaded the colors.tif file and tried
to print this: Success. It worked.

Then I loaded the penguin again and it printed fine. Where are we
using /dev/random to determine the success or failure of a print?

BTW: I did powercycle the printer a few times when it was not
working just to make sure that none of my other jobs (ghostscript
with uniprint driver) left the printer in a funny state.=20

Karl Heinz
--=20
Karl Heinz Kremer                                      kh...@kh...
                                                http://www.khk.net