Re: [Gimp-print-devel] Width and Height OK with stc740

[Karl H. K. <kh...@kh...>]

On Fri, Feb 18, 2000 at 08:36:02PM -0500, Robert L Krawitz wrote:
> BTW, could you check in your latest unprint when you get a chance?
> If we get even halfway decent printing on the 740 (the bits come out
> in the right place), I want to do the release this weekend or at
> latest Monday, to get the code out there.

I had a minute today and I tried my test image a few time on different
places on the page with 720 dpi softweave: It worked most of the time -
I got a perfect picture. However, a few times the printer behaved like
before: Just spitting out the blank page. Is it possible that something
with the vertical/horizontal motion commands is wrong? It could also be
that I still had some bytes in the queue or in the driver from the last
job that were send to the printer and screwing up the job. I should be
able to do some more testing tomorrow. I did not test any of the other
modes, and I only used the variable dot size.=20

One other thing that I noticed is that the location of the image on=20
the page seems to be off: I placed the image on various places, and
it looks like if I place it about halfway across the page horizontally
it ends up on the right edge (I'm still using the small penguin, the
image is about half an inch each side, so this is definitely not
correct).

I'll let you know what I find out tomorrow.

Karl Heinz

--=20
Karl Heinz Kremer                                      kh...@kh...
                                                http://www.khk.net