Re: [Gimp-print-devel] stc740 now understands ESC(U, but ...

[<sh...@al...>]

>    > In softweave mode, or microweave?
> 
>    I believe it was using microweave mode.
> 
> The really slow (1 line/pass) way?

No, I'm sorry.  I just checked the source.  Microweave is off, if I'm reading
it correctly.

>  What I'm really concerned about is
> softweave.  Even a boat anchor will print in (pseudo)microweave mode.

Wow, you must be a better programmer than I.  I don't think I could get a
boat anchor to print, even in microweave mode.

Eric