Hi,
I am using genode 15.08 on IMX6.
When I am trying to run the framebuffer driver it is showing up the error as shown in the image link given. Image Link
The first error is : Could not open file "config", which I think is being shown as there is no config file.
My question is that where should I keep the config file and what should be the contents of the file?
Also for "no RM attachment" error message, I included the perf_counter in the specs.conf file in \<build_dir>\etc but this particular error is persistent.
How can I solve this?
Thank You.
Regards,
Aniket
Last edit: Aniket Dutta 2018-07-24
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I am using genode 15.08 on IMX6.
When I am trying to run the framebuffer driver it is showing up the error as shown in the image link given.
Image Link
The first error is : Could not open file "config", which I think is being shown as there is no config file.
My question is that where should I keep the config file and what should be the contents of the file?
Also for "no RM attachment" error message, I included the perf_counter in the specs.conf file in \<build_dir>\etc but this particular error is persistent.
How can I solve this?
Thank You.
Regards,
Aniket
Last edit: Aniket Dutta 2018-07-24
Hello,
please note that very few people frequent this forum and Genode discussion happens on the mailing list
http://genode.org/community/mailing-lists
If you subscribe to the list and post there, I expect that you get profound tips from the community.
Regards
Christian