GeigerLog pre-release 1.5.1pre04
Python program for Geiger counters and Environmental Sensors
Brought to you by:
ullix
Menu
▾
▴
This pre-release finalizes the support of GQ's EMF Devices to GeigerLog. It was developed with the EMF390 device, but should also work with older devices.
It supports both Logging and History (where supported by the device).
To use, please install GeigerLog according to instructions in its 1.5.0 manual. Then activate a [GEMF_Device], connect your device to the computer, and run GeigerLog.
If you experience any problems, please report as a Ticket here on this site.