I translate the attached layer map into a process defintion file as you suggested in the read me file. but when I run the GDS3D, it is always saying that there is no subtrate layer although I added it. Can you help to resolve this? thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Thanks Michiel, it is now working. The only problem now is how to rescale the dimension of the green layer(I belive it's the substrate)? my layout is very small compared to the generated green substrate (see attached screenshot)
Hi,
I translate the attached layer map into a process defintion file as you suggested in the read me file. but when I run the GDS3D, it is always saying that there is no subtrate layer although I added it. Can you help to resolve this? thanks
The process defintion file is attached here
The process layer map codes is attached here. sorry I could't attach them both at ones, not sure why.
would you please advise me if the my layer defintion is right?
Looking at your ProcessDef.txt, I see you have tabs in most of the lines. Try to remove the tabs, like in example.txt and try again.
Thanks Michiel, it is now working. The only problem now is how to rescale the dimension of the green layer(I belive it's the substrate)? my layout is very small compared to the generated green substrate (see attached screenshot)