I'm sure this info is available somewhere in this forum but would it be possible to provide default command lines for Pickit2 and Pickit3? Everything I've tried results in -1.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If this is PK+ and the version I provided then many of the switches wont work. We provided you a an eval version of a very early version. But, in the spirit of sharing the word... look at https://www.youtube.com/watch?v=Uo7z1wfjIh8&t=253s
The action start 5:29s - faster than typing here....
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
The IDE has PK2 programmers CLI built in for the old Microchip PKCMD. For the software look in your GCB installation. The PK2 folders.
There is no PK3 CLI unless you use MP-IDE. For the software look in your GCB installation - the PK3 folders.
And, we have a lovely new programmer software... PICKit:AutoWatch. Software that supports both PK2 and PK3. All good stuff and no need to learn the CLI command line switches.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm sure this info is available somewhere in this forum but would it be possible to provide default command lines for Pickit2 and Pickit3? Everything I've tried results in -1.
For what software?
If this is PK+ and the version I provided then many of the switches wont work. We provided you a an eval version of a very early version. But, in the spirit of sharing the word... look at https://www.youtube.com/watch?v=Uo7z1wfjIh8&t=253s
The action start 5:29s - faster than typing here....
I was thinking non-plus Pickit2 and Pickit3. I don't have plus versions.
"For what software?" GCB.
You must have deleted it then. Thank you.
The IDE has PK2 programmers CLI built in for the old Microchip PKCMD. For the software look in your GCB installation. The PK2 folders.
There is no PK3 CLI unless you use MP-IDE. For the software look in your GCB installation - the PK3 folders.
And, we have a lovely new programmer software... PICKit:AutoWatch. Software that supports both PK2 and PK3. All good stuff and no need to learn the CLI command line switches.
"For the software look in your GCB installation. The PK2 folders." I was hoping for the command line parameters.
AutoWatch sounds great.
Last edit: George Towler 2019-11-14