Can I just unzip the greatcowbasic folder (in the hot_fix.zip) over my greatcowbasic folder to be current?
I did not have the other stuff before (pickit*, etc)? I have the older version running and just use a c.bat to compile for MLABASM and the /k:a switch. I run from the command line. Or does the pickit 2 allow debugging (I do have one)?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Just checking. Are you using GCGB? If yes. Then, do not copy the Great Cow Graphical BASIC.EXE as this is pre-release version.
Back-up your old folder, clean up the old folder and un-zip.
Restore any files up required.
Have a look at the GCB@SYN. It contains methods to compile and program your devices. This may or may not meet your needs and could (or could not) replace c.bat.
Note: If you have adapted an .h files these may have been updated to the latest version.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Can I just unzip the greatcowbasic folder (in the hot_fix.zip) over my greatcowbasic folder to be current?
I did not have the other stuff before (pickit*, etc)? I have the older version running and just use a c.bat to compile for MLABASM and the /k:a switch. I run from the command line. Or does the pickit 2 allow debugging (I do have one)?
Questions:
Restore any files up required.
Have a look at the GCB@SYN. It contains methods to compile and program your devices. This may or may not meet your needs and could (or could not) replace c.bat.
Note: If you have adapted an .h files these may have been updated to the latest version.