Hi again everyone, I’m looking for some help or stimulus with this next stage of another project.
What I am trying to do is interface a DIGIPOT 5Bit 32 Step Up/Down POT with 12F508. The 12F508 has to respond to an RC PWM. With the excellent help from Kent, I now have some very stable code which gives me an Output on One Pin.
What I need to be able to do now is to increment another output Pin by a single 100mS (or thereabouts) pulses or 32 steps as the PWM signal increases and then decrement by the same 32 Steps on another Output Pin.
I have tried to ‘Go it Alone’ but I keep hitting a wall. Once again, any help would be really appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi again everyone, I’m looking for some help or stimulus with this next stage of another project.
What I am trying to do is interface a DIGIPOT 5Bit 32 Step Up/Down POT with 12F508. The 12F508 has to respond to an RC PWM. With the excellent help from Kent, I now have some very stable code which gives me an Output on One Pin.
What I need to be able to do now is to increment another output Pin by a single 100mS (or thereabouts) pulses or 32 steps as the PWM signal increases and then decrement by the same 32 Steps on another Output Pin.
I have tried to ‘Go it Alone’ but I keep hitting a wall. Once again, any help would be really appreciated.