I saw samples with last release of GCBASIC and there are samples that need ERACER.H ,
This .H is not in the last version, but I downloaded it in the old version.
I searched on the web what is ERACER, I saw , it is a little board for "line follower", a little robot with a pic16F819.
And there is some board to sold on the web ...
But I didn't find any schematic on the web, for that board !
I saw in the .H there is a motor driver , 2 leds left,right, 2 leds green,red , buzzer, 2 probes IR ...
What else (buttons?) ?
Can we download a schematic somewhere ?
Or if it is not possible for a schematic, to have a good quality photo of the 2 sides ?
I can make a schematic with the .h but Perhaps it will not be complete...
Or just use a breadboard for test samples...
hello,
I saw samples with last release of GCBASIC and there are samples that need ERACER.H ,
This .H is not in the last version, but I downloaded it in the old version.
I searched on the web what is ERACER, I saw , it is a little board for "line follower", a little robot with a pic16F819.
And there is some board to sold on the web ...
But I didn't find any schematic on the web, for that board !
I saw in the .H there is a motor driver , 2 leds left,right, 2 leds green,red , buzzer, 2 probes IR ...
What else (buttons?) ?
Can we download a schematic somewhere ?
Or if it is not possible for a schematic, to have a good quality photo of the 2 sides ?
I can make a schematic with the .h but Perhaps it will not be complete...
Or just use a breadboard for test samples...
thanks.
best regards
Pat
My user name; pat007-2014
I found a complete manual file;
http://www.elabtronics.com/downloads/eRacer_16m_Manual.pdf
no real schematic but the PCB is complete
here;
http://www.elabtronics.com/eracer16m.php
The IR sensors are on the side not below , it is not a line follower but the electronic is the same.