While poking around in the low-level include files today, I noticed there is an IR remote control header there. Since there are almost no comments within it, it's hard to tell for sure if it's for the NRC protocol or the RC-5, or both for that matter.
Anyway, since it's in the low-level folder, it suggests to me that it's a permanent part of the language and really should be documented in the Help file. Presumably it was composed by Hugh, so maybe if he gets a moment he could write up some quick instructions for the Help file.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Is this your answer to my request for help create control IR code reader? I already try using pulsein command, but do not successfully.
maybe you or someone else can help???
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
While poking around in the low-level include files today, I noticed there is an IR remote control header there. Since there are almost no comments within it, it's hard to tell for sure if it's for the NRC protocol or the RC-5, or both for that matter.
Anyway, since it's in the low-level folder, it suggests to me that it's a permanent part of the language and really should be documented in the Help file. Presumably it was composed by Hugh, so maybe if he gets a moment he could write up some quick instructions for the Help file.
Hallo, Thomas Henry!
Is this your answer to my request for help create control IR code reader? I already try using pulsein command, but do not successfully.
maybe you or someone else can help???