12F683 Inputs

[Dermot Donnelly]

Hi,
I'm using GCB 6.22.2290 and the 12F683. I need to have two inputs and 4 outputs. I'm using GPIO.5 and GPIO.3 as inputs and GPIO.0, GPIO.1, GPIO.2 amd GPIO.4 as outputs. When I bring an input high I want to get an output to go high. When I do this with GPIO.3 I get one of my outputs to go high no problem. When I do the same thing with GPIO.5 it doesn't work. I think it's because GPIO.5 is a serial in pin as well as an input pin.

Is there some command I can use to turn GPIO.5 into an input pin like GPIO.3?

I attach the code. Thank you in advance.
Regards
Dermot

[Dermot Donnelly]

Sorry folks. Everything works fine. I had a pull down resistor on my breadboard for GPIO.5 and it was a bit loose. DOH!

[Anobium]

No problem.

A quick scan of your code. I would move the setup before Start:

Dir GPIO.0 Out
Dir GPIO.1 Out
Dir GPIO.2 Out
Dir GPIO.3 In
Dir GPIO.4 Out
Dir GPIO.5 In
Dim SwState1 as Byte   'o=off  8=on
Dim SwState2 as Byte


Start:

Cheers

[Dermot Donnelly]

Thanks for the help. Really fast response. Great forum. I've donated the £23 for the Pickit Plus even though I don't need it. The free stuff you give is easily worth that.
Regards
Dermot

[Anobium]

You are a gentleman. Every penny helps and I do hope you will take advantage of the new features.

Thank you.