Re: [Fx2lib-devel] new, just found this list

[Gerry R. <ge...@ro...>]

> I'd planned on adding two more example programs.  One reads/writes 
> eeprom data.  The other resets the fx2 development board to it's default 
> state if you bork the eeprom data.  You can't do the latter on a real 
> board usually though!  The eeprom routines are already there in the 
> library though.  The fx2 is hard coded to boot from a certain prom 
> address so it's likely even if it's not on the development board, that 
> any other board uses the same eeprom address on the i2c bus.  In other 
> words, the lib routines should work correctly on your device.  I'll post 
> those examples here in a bit.
>   
I've been doing more reading, and, I think this is the issue I had, I 
was _assuming_ rather incorrectly that the eeprom would be address 0 on 
the i2c bus.  Just working up a test program to try walking thru all i2c 
addresses and read the first couple of bytes from each address.

I'm expecting to find a C0 eeprom, and, the device id of the cmos sensor 
hiding somewhere on that bus.