I'm not used to work with FW builder and now must create the firewall rules with the gui.
Normally I create the firewall rules with the IPtables command.
I'm a bit stuck with the Natting.
eth0 is my LAN and eth3 is my internet, and i need to NAT eth0 behind the eth3 address.
normally i would do something like:
iptables -table nat -append POSTROUTING -out-interface eth3 -j MASQUERADE
iptables -append FORWARD -in-interface eth0 -j ACCEPT
But how do I this with FWbuilder until no i have nu luck
this chapter of Firewall Builder Users Guide should help:
Log in to post a comment.