Re: [Ftdi-usb-sio-devel] Support of USB to FIFO parallel device

[Bill R. <br...@pa...>]

I have only tested with the 245AM so far so I am not sure what issues 
you might have. Assuming the protocol to talk to the device is the same 
at the most you should just need to change the vendor/product id.

Please note that the linux driver is not written for performance so the 
maximum data transfer rate full-duplex is likely to be only about 1Mbps 
(bits per second) depending on your host.

Stephen Noftall wrote:

>Hello;
>
>I am using FTDI's FT245BM chip with Linux on an embedded board I am
>designing.
>
>I was wondering if anyone has used this chip before? Is there any gotchas
>with it?
>
>Thanks for any heads up.
>
>Stephen Noftall
>
>
>
>
>
>-------------------------------------------------------
>This sf.net email is sponsored by:ThinkGeek
>Welcome to geek heaven.
>http://thinkgeek.com/sf
>_______________________________________________
>Ftdi-usb-sio-devel mailing list
>Ftd...@li...
>https://lists.sourceforge.net/lists/listinfo/ftdi-usb-sio-devel
>
>
>  
>