I am new to libical. I have run into a few build problems. I am using
version 0.46. I am on Windoze using both cygwin and Visual Studio 2005
First the problems under cygwin: 0.44 builds just fine but 0.46 says:
config.status: error: cannot find the input file: zoneinfo/Makefile.in.
If I copy the Makefile.in from version 0.44 and (re)configure then I get a
config.status: error: cannot find the input file: Makefile.in.
If I copy that one from 0.44 and (re)configure then I get a similar error
for the next Makefile.in it can't find, and so on.....
It looks to me like there has been some packaging error in the release of
version 0.46. With all the Makefile.in files in place configure then
config.status: error: cannot find the input file: config.h.in.
At this point I gave up trying to build 0.46 with cygwin.
Now for the problem under VS: it says the dsp file for libical is corrupt
and refuses to open it. I get the same problem on vesion 0.44.
The README.win32 file talks about dsp files for VS6. This makes me wonder
about WIN32 support. VS6 is ancient and has an unusable STL (most people
replace it with the one from Dinkumware). I know that VS8 is also quite
old but unfortunately this is the version I am stuck with. At least VC8
comes with a usable STL. So I would very much like to build libical using
it. Has anyone else done this please?
This e-mail may contain confidential and/or privileged information. If you are not the intended recipient (or have received this e-mail in error) please notify the sender immediately and delete this e-mail. Any unauthorised copying, disclosure or distribution of the material in this e-mail is prohibited.
Please refer to http://www.bnpparibas.co.uk/en/information/legal_information.asp?Code=ECAS-845C5H for additional disclosures.