I'm glad you're getting the data stored OK. I would have to know more about where FlowViewer is not seeing your data. Does the FlowViewer GUI come up? If it is, can you post your FlowViewer_Configuration.pm file?
Thanks,
Joe
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm assuming that FlowMonitor is not working for you? Click on FlowMonitor and fill out a form, make sure you have some specifc filtering data (e.g., an IP range, an interface number, etc.) as FlowMonitor sometimes does not respond well to 'empty' FlowMonitor filters.
Regards,
Joe
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone,
I use netflow pfsense that sends data to / var / flows / MYROUTER
I have installed the interface flowviewer but I no data recovered.
Yet in my file /var/flows/MYROUTER,there is full of files
where the problem may well come
cordially
ps : sorry for my bad english
Last edit: juan-marco 2016-01-07
It´s good i recovery data but the monitor does not.
Hi Juan-Marco,
I'm glad you're getting the data stored OK. I would have to know more about where FlowViewer is not seeing your data. Does the FlowViewer GUI come up? If it is, can you post your FlowViewer_Configuration.pm file?
Thanks,
Joe
Thanks for your answers.
I have graph and data but monitor doesn´t work
cordially
Hi Juan-Marco,
I'm assuming that FlowMonitor is not working for you? Click on FlowMonitor and fill out a form, make sure you have some specifc filtering data (e.g., an IP range, an interface number, etc.) as FlowMonitor sometimes does not respond well to 'empty' FlowMonitor filters.
Regards,
Joe