Re: [Flex-help] flex 2.6.0 lexer cannot be restarted on Solaris 11.3
flex is a tool for generating scanners
Brought to you by:
wlestes
Menu
▾
▴
Re: [Flex-help] flex 2.6.0 lexer cannot be restarted on Solaris 11.3
|
From: Mark B. <cha...@ya...> - 2016-06-06 09:29:36
|
Hi Dennis, Thanks for your reply, that would be very helpful. Yes I know Solaris is not Linux :-) My project has been compiling successfully on Solaris since 2002 and I've always used flex and bison. I changed two things recently: I upgraded from flex 2.5.4 and I compiled on Solaris 11.3 for the first time. It compiled on Solaris 11.1 fine in the past (and earlier versions of Solaris). I tried reverting back to flex 2.5.4 but I get the same problem. Not sure how to debug this any further? Best regards,Mark. On Sun, 5 Jun, 2016 at 21:08, Dennis Clarke<dc...@bl...> wrote: On 06/04/2016 03:28 AM, Mark Bannister wrote: > Hi, > > > I'm having trouble with flex here (flex 2.6.0 and bison 3.0.4). Firstly .. Solaris is not Linux. It is UNIX(tm). So expect just about anything non-portable from the linux world to be a struggle. However flex is pretty darn good software. So I'll go get the sources and have a look on a baseline Solaris 10 system and then move upwards to a SPARC M7 based Sol 11.3 system and then get back to you on this. Dennis ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e -- Flex-help mailing list Fle...@li... https://lists.sourceforge.net/lists/listinfo/flex-help |
