I'm trying to get FlashForth working on this pic using UART2. There was no definition in p18fxxxx.cfg so I created one, and had to short the flash_hi memory because this part has 128K memory which takes more than 16 bits to address. All compiles and loads but no joy getting anything out the serial port. Looking in the debugger I see it looking for RX activity but not picking up any input from the receiver. I do see that the code sets the ANSEL18 bit to digital which I found hopeful, but no amount to 'sending' data on uart 2 elicites any change/response.
Any suggestions?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm trying to get FlashForth working on this pic using UART2. There was no definition in p18fxxxx.cfg so I created one, and had to short the flash_hi memory because this part has 128K memory which takes more than 16 bits to address. All compiles and loads but no joy getting anything out the serial port. Looking in the debugger I see it looking for RX activity but not picking up any input from the receiver. I do see that the code sets the ANSEL18 bit to digital which I found hopeful, but no amount to 'sending' data on uart 2 elicites any change/response.
Any suggestions?
This chip is not supported by flashforth At least the flash write routine will not work.